Strength Analysis of the Front Bumper Beam of a Passenger Car

Authors

  • A. Śliwa Silesian University of Technology, Faculty of Mechanical Engineering, Institu e of Materials Engineering and Biomedical Sciences, 18A S. Konarskiego St r., 44-100 Gliwice, Poland https://orcid.org/0000-0001-9459-3895
  • W. Mikołejko Silesian University of Technology, Faculty of Mechanical Engineering, Institu e of Materials Engineering and Biomedical Sciences, 18A S. Konarskiego St r., 44-100 Gliwice, Poland https://orcid.org/0000-0002-8050-1168
  • M. Bonek Silesian University of Technology, Faculty of Mechanical Engineering, Institu e of Materials Engineering and Biomedical Sciences, 18A S. Konarskiego St r., 44-100 Gliwice, Poland
  • A. Dziwis Silesian University of Technology, Faculty of Mechanical Engineering, Institu e of Materials Engineering and Biomedical Sciences, 18A S. Konarskiego St r., 44-100 Gliwice, Poland https://orcid.org/0000-0001-7004-8198

DOI:

https://doi.org/10.24425/amm.2024.149801

Abstract

This article presents a computer simulation carried out in the Solidworks environment, the bumper beam of a passenger car was tested. The simulation took into account the influence of various aluminum alloys and the type of reinforcement in the crosssection of the beam on the strength of the entire element at the time of collision at different forces. The analysis provided answers in which places the accumulation of stresses occurs, and thus the places most exposed to destruction

Published

2024-06-21

How to Cite

Śliwa, A., et al. “Strength Analysis of the Front Bumper Beam of a Passenger Car”. Archives of Metallurgy and Materials, vol. 69, no. 2, June 2024, doi:10.24425/amm.2024.149801.

Issue

Vol. 69 No. 2 (2024)

Section

Articles