The Study of Copper Alloy with Graphene Additive via x-Ray Diffraction

Authors

  • M.N. Masri Universiti Malaysia Kelantan, Faculty of Bioengineering and Technology, 17600 Jeli Kelantan, Malaysia https://orcid.org/0000-0003-2577-6756
  • M. Mohammad Universiti Malaysia Kelantan, Faculty of Bioengineering and Technology, 17600 Jeli Kelantan, Malaysia
  • M. Yusoff Universiti Malaysia Kelantan, Faculty of Bioengineering and Technology, 17600 Jeli Kelantan, Malaysia https://orcid.org/0000-0002-3581-1001
  • S. Mamat Universiti Malaysia Kelantan, Faculty of Bioengineering and Technology, 17600 Jeli Kelantan, Malaysia https://orcid.org/0000-0002-5997-4075
  • P.T. Teo Universiti Malaysia Kelantan, Faculty of Bioengineering and Technology, 17600 Jeli Kelantan, Malaysia https://orcid.org/0000-0002-2012-5981
  • R. Othman Urich Technology (KC0023880-A), No. 457, Lorong 7/1, Taman Semarak, 08000 Sungai Petani, Kedah, Malaysia
  • A.R. Irfan Universiti Malaysia Perlis, Center of Excellence Geopolymer and Green Technology (CEGeoGTech), Perlis, Malaysia https://orcid.org/0000-0002-6606-9874
  • Pramod K. Singh Sharda University, School of Basic Sciences and Research, Department of Physics, Center of Excellence on Solar Cells & Renewable Energy, Greater Noida, Uttar Pradesh 201308, India https://orcid.org/0000-0003-2212-0583

DOI:

https://doi.org/10.24425/amm.2022.139701

Abstract

This study evaluated the effect of milling speed and compaction pressure on the densification and morphology of the CuZn-Gr composite. The composite was prepared by using the powder metallurgy technique. The effect on the microstructural and compaction was determined based on different milling speeds. The different milling speeds involved were 175, 200, 225, and 250 rpm. Meanwhile, the different compaction pressures used in this study were 127, 250, 374, and 500 MPa. The properties of the milled powder gave the result to green density and densification parameters. The XRD pattern of Cu and Zn broadened as milling time increased.

Published

2022-08-26

How to Cite

Masri, M.N., et al. “The Study of Copper Alloy With Graphene Additive via X-Ray Diffraction”. Archives of Metallurgy and Materials, vol. 67, no. 3, Aug. 2022, doi:10.24425/amm.2022.139701.

Issue

Vol. 67 No. 3 (2022)

Section

Articles