Concept of a test stand for electricity generation from waste heat using wet steam

Authors

  • Wiesław Zima Department of Energy, Cracow University of Technology, Al. Jana Pawła II 37, Cracow 31-864, Poland
  • Artur Cebula Department of Energy, Cracow University of Technology, Al. Jana Pawła II 37, Cracow 31-864, Poland
  • Karol Morański Department of Energy, Cracow University of Technology, Al. Jana Pawła II 37, Cracow 31-864, Poland
  • Jerzy Cisek Mechanical Department, Cracow University of Technology, Al. Jana Pawła II 37, Cracow 31-864, Poland

DOI:

https://doi.org/10.24425/ather.2025.154905

Abstract

The paper presents a concept of an innovative test stand for converting waste heat into electricity using wet steam. Two expanders will be tested, i.e. a rotary blower and a scroll compressor, which have been adapted for reverse cycle operation. The main objective of the stand is to verify experimentally the feasibility of the effective use of an innovative wet steam cycle for waste heat recovery. To verify the design assumptions, as well as the stand configuration and parameters, preliminary simulations were carried out in Ebsilon software. The solution innovation lies in using wet steam to enhance waste heat recovery. Wet steam is generated on the test stand by injecting water into saturated steam using a specially designed nozzle system. In this way, steam dryness can be controlled precisely and proper conditions are created for the expander operation. Saturated steam is generated in the boiler installed at the laboratory of the Department of Energy of the Cracow University of Technology. The test stand will enable the system operation and an assessment of the system’s potential applications. This will help to improve the energy efficiency of waste heat utilization and reduce emissions.

References

[1] Daniarta, S., Kolasiński, P., & Imre, A.R. (2021). Thermodynamic efficiency of trilateral flash cycle, organic Rankine cycle and partially evaporated organic Rankine cycle. Energy Conversion and Management, 249, 114731. https://doi.org/10.1016/j.enconman.2021.114731

[2] Xu, Z.Y., Wang, R.Z., & Yang, Ch. (2019). Perspectives for low-temperature waste heat recovery. Energy, 176, 1037–1043. https://doi.org/10.1016/j.energy.2019.04.001

[3] Woolley, E., Luo, Y., & Simeone, A. (2018). Industrial waste heat recovery: A systematic approach. Sustainable Energy Technologies and Assessments, 29, 50–59. https://doi.org/10.1016/j.seta.2018.07.001

[4] Panayiotou, G.P., Bianchi, G., Georgiou, G., Aresti, L., Argyrou, M., Agathokleous, R., Tsamos, K.M., Tassou, S.A., Florides, G., Kalogirou, S., & Christodoulides, P. (2017). Preliminary assessment of waste heat potential in major European industries. Energy Procedia, 123, 335–345. https://doi.org/10.1016/j.egypro.2017.07.263

[5] Firth, A., Zhang, B., & Yang, A. (2019). Quantification of global waste heat and its environmental effects. Applied Energy, 235, 1314–1334. https://doi.org/10.1016/j.apenergy.2018.10.102

[6] Macchi, E., & Astolfi, M. (Eds.) (2016). Organic Rankine cycle (ORC) power systems: Technologies and applications. Woodhead Publishing.

[7] Mahmoudi, A., Fazli, M., & Morad, M.R. (2018). A recent review of waste heat recovery by Organic Rankine Cycle. Applied Thermal Engineering, 143, 660–675. https://doi.org/10.1016/j.applthermaleng.2018.07.136

[8] Tian, H., Wang, X., Shu, G., Wu, M., Yan, N., & Ma, X. (2017). A quantitative risk-assessment system evaluating operation safety of Organic Rankine Cycle using flammable mixture working fluid. Journal of Hazardous Materials, 338, 394–409. https://doi.org/10.1016/j.jhazmat.2017.05.039

[9] Klimaszewski, P., Zaniewski, D., Witanowski, Ł., Suchocki, T., Klonowicz, P., & Lampart, P. (2019). A case study of working fluid selection for a small-scale waste heat recovery ORC system. Archives of Thermodynamics, 40(3), 159–180. https://doi.org/10.24425/ather.2019.129999

[10] Song, J., & Gu, Ch. (2015). Performance analysis of a dual-loop organic Rankine cycle system. Applied Energy, 156, 280–289. https://doi.org/10.1016/j.apenergy.2015.07.019

[11] Safarian, S., & Aramoun, F. (2015). Energy and exergy assessments of modified organic Rankine cycles. Energy Reports, 1, 1–7. https://doi.org/10.1016/j.egyr.2014.10.003

[12] Bianchi, G., McGinty, R., Oliver, D., Brightman, D., Zaher, O., Tassou, S.A., Miller, J., & Jouhara, H. (2017). Development and analysis of a packaged trilateral flash cycle system. Thermal Science and Engineering Progress, 4, 113–121. https://doi.org/10.1016/j.tsep.2017.09.009

[13] Smith, I.K. (1993). Development of the trilateral flash cycle system: Fundamental considerations. Proceedings of the IMechE Part A, 207, 179–194. https://doi.org/10.1243/pime_proc_1993_207_032_02

[14] Bianchi, G., Marchionni, M., Miller, J., & Tassou, S.A. (2020). Modelling and optimisation of trilateral flash cycle system. Applied Thermal Engineering, 179, 115671. https://doi.org/10.1016/j.applthermaleng.2020.115671

[15] Steffen, M., Löffler, M., & Schaber, K. (2013). Efficiency of a triangle cycle with flash evaporation. Energy, 57, 295–307. https://doi.org/10.1016/j.energy.2012.11.054

[16] Fischer, J. (2011). Comparison of trilateral cycles and ORCs. Energy, 36, 6208–6219. https://doi.org/10.1016/j.energy.2011.07.041

[17] Zeynali, A., Akbari, A., & Khalilian, M. (2019). Performance of modified ORC and TFC cycles with solar pond. Solar Energy, 182, 361–381. https://doi.org/10.1016/j.solener.2019.03.001

[18] Iqbal, M.A., Rana, S., Ahmadi, M., Date, A., & Akbarzadeh, A. (2020). Experimental study on trilateral flash cycle. Applied Thermal Engineering, 172, 115139. https://doi.org/10.1016/j.applthermaleng.2020.115139

[19] Guerron, G., Nicolalde, J.F., Martínez-Gómez, J., & Dávila, P. (2024). Waste heat recovery prototype based on Rankine cycle. Applied Thermal Engineering, 257(A), 124233. https://doi.org/10.1016/j.applthermaleng.2024.124233

[20] Imran, M., Usman, M., Park, B.-S., & Lee, D.H. (2016). Volumetric expanders for waste heat recovery. Renewable and Sustainable Energy Reviews, 57, 1090–1109. https://doi.org/10.1016/j.rser.2015.12.139

[21] Du, Y., Tian, G., & Pekris, M. (2023). CFD modelling of scroll expander. Energy Conversion and Management, 282, 116857. https://doi.org/10.1016/j.enconman.2023.116857

[22] Zhen, K., Shi, L., Zhang, Y., & Peng, B. (2024). Performance prediction of scroll expander. Case Studies in Thermal Engineering, 60, 104766. https://doi.org/10.1016/j.csite.2024.104766

[23] Ma, X., Lv, X., Li, Ch., & Li, K. (2023). Accurate modelling of scroll expander. International Journal of Refrigeration, 155, 32–46. https://doi.org/10.1016/j.ijrefrig.2023.09.005

[24] Heliex Power Technology. Twin screw turbine. https://www.heliexpower.com/technology [accessed 24 Apr. 2024].

[25] Kaeser (2011). Report Spring 2011. http://www.kaeser.com

[26] STEAG Energy Services GmbH (2019). Ebsilon Professional Version 14.02 – Release (Patch 2).

[27] Kim, H.J., Ahn, J.M., Park, I., & Rha, P.C. (2007). Scroll expander for power generation from low-grade steam. Proceedings of the IMechE Part A, 221(5), 705–711. https://doi.org/10.1243/09576509JPE392

Downloads

Published

2025-06-30

How to Cite

Zima, Wiesław, et al. “Concept of a Test Stand for Electricity Generation from Waste Heat Using Wet Steam”. Archives of Thermodynamics, vol. 46, no. 2, June 2025, pp. 49-56, doi:10.24425/ather.2025.154905.

Issue

Section

Articles

Similar Articles

<< < 26 27 28 29 30 31 32 > >> 

You may also start an advanced similarity search for this article.