Design and calibration method for precise temperature sensor

Authors

  • Kamil Stepniewski Institute of Microelectronics and Optoelectronics, Warsaw University of Technology, Warsaw, Poland
  • Bartosz Dec Institute of Microelectronics and Optoelectronics, Warsaw University of Technology, Warsaw, Poland
  • Arkadiusz Łuczyk Institute of Microelectronics and Optoelectronics, Warsaw University of Technology, Warsaw, Poland
  • Jakub Jasiński Institute of Microelectronics and Optoelectronics, Warsaw University of Technology, Warsaw, Poland
  • Krzysztof Siwiec Institute of Microelectronics and Optoelectronics, Warsaw University of Technology, Warsaw, Poland

DOI:

https://doi.org/10.24425/ijet.2025.156675

Abstract

This paper presents the design of the temperature sensor and analysis of different calibration methods. The main aspect of the analysis was optimization of the number and location of the measurement points needed to perform the calibration for a given accuracy. For this purpose, temperature sensors using proportional to the absolute temperature (PTAT) current and current controlled oscillator (CCO) have been designed in 180 nm technology. To reduce the sensitivity of the sensor to the supply voltage, the low dropout regulator (LDO) has been used. The bandgap circuit generates the stable reference voltage for the LDO and PTAT current for the CCO.

Published

2025-10-22

How to Cite

Stepniewski, Kamil, et al. “Design and Calibration Method for Precise Temperature Sensor”. International Journal of Electronics and Telecommunications, vol. 71, no. 4, Oct. 2025, doi:10.24425/ijet.2025.156675.

Issue

Section

Artykuły

Most read articles by the same author(s)