Reconstruction of Strains with a Non-smooth Distribution and Temperature Using Optical Fiber Bragg Grating

Authors

  • Małgorzata Detka Faculty of Electrical Engineering, Automatic Control and Computer Science, Kielce University of Technology, Poland
  • Cezary Kaczmarek Faculty of Electrical Engineering and ComputerScience, Lublin University of Technology, Poland

DOI:

https://doi.org/10.24425/ijet.2022.141271

Abstract

This paper presents a simulation study of the simultaneous reconstruction of the non-smooth strain distribution of an optical fiber Bragg grating and its temperature, which is based on the reflection spectrum of the reflected beam of the grating. The transition matrix method was used to model the reflection spectrum of the grating, and the nonlinear Nelder- Mead optimization method was used to simultaneously reconstruct the strain distribution along the grating and its temperature. The results of simulations of simultaneous reconstruction of the strain profile and temperature indicate good accord with the strain profiles and temperature set. The reconstruction errors of the strain profiles are less than 1.2 percent and the temperature change errors are less than 0.2 percent, with a noise level of 5 percent.

Published

2022-09-06

How to Cite

Detka, Małgorzata, and Cezary Kaczmarek. “Reconstruction of Strains With a Non-Smooth Distribution and Temperature Using Optical Fiber Bragg Grating”. International Journal of Electronics and Telecommunications, vol. 68, no. 3, Sept. 2022, doi:10.24425/ijet.2022.141271.

Issue

Section

Artykuły