Design, Simulation, and Experimental Validation of a Multiband Cable Antenna for IoT Applications

Authors

  • Magdalena Budnarowska Department of Power Electronics, Faculty of Electrical Engineering, Gdynia Maritime University, Gdynia, Poland
  • Jerzy Mizeraczyk Department of Power Electronics, Faculty of Electrical Engineering, Gdynia Maritime University, Gdynia, Poland
  • Michał Zera Department of Power Electronics, Faculty of Electrical Engineering, Gdynia Maritime University, Gdynia, Poland
  • Dawid Budnarowski Department of Marine Telecommunications, Faculty of Electrical Engineering, Gdynia Maritime University, Gdynia, Poland

DOI:

https://doi.org/10.24425/ijet.2026.6311

Abstract

The paper presents the design, numerical modeling, and experimental validation of a low-cost multiband cable antenna intended for Internet of Things (IoT) applications. The proposed antenna is based on a modified coaxial cable structure that acts as a radiator, enabling operation in multiple frequency bands, including the 868 MHz and 2.4 GHz ISM bands. The antenna design was developed in the CST Studio Suite environment and subsequently validated experimentally using a vector network analyzer (VNA). To assess fabrication repeatability, the frequency characteristics of four identical antenna prototypes were measured. The measured S11 reflection coefficient demonstrated stable multiband operation consistent with the simulation results. The proposed solution represents an attractive alternative to conventional external antennas in IoT systems.

Downloads

Published

2026-10-29

How to Cite

Budnarowska, Magdalena, et al. “Design, Simulation, and Experimental Validation of a Multiband Cable Antenna for IoT Applications ”. International Journal of Electronics and Telecommunications, vol. 72, no. 4, Oct. 2026, pp. 1-6, doi:10.24425/ijet.2026.6311.

Issue

Section

Artykuły